Written by the Motorplex Team
Providing 24/7 on-site fleet repairs in the Pacific Northwest
Recently, Motorplex responded to a call for an on-site fleet repair and inspection in Ellensburge, Washington. The driver of a 2024 Freightliner Cascadia noticed brake issues while driving at night. They suspected that one of the brake chambers had an air leak, but were unsure which one was failing.
When our technician and mobile repair unit arrived, we found the spring brake section on the passenger-side wheel of that axle. Fortunately, our technician replaced the brake chamber, provided a courtesy inspection for the driver, and sent him on his way.
What Happens Inside a Broken Brake Chamber?
How does a brake chamber work? A brake chamber on a semi-truck converts compressed air into mechanical force to apply the wheel brakes. When you press the brake pedal, pressurized air pushes an internal diaphragm, extending a pushrod that moves the slack adjuster and applies the brakes.
A few things can cause a brake chamber to malfunction:
Ruptured diaphragm: If the diaphragm tears, then pressurized air can’t hold the heavy coil springs back. Tell-tale signs are a loud, continuous hissing sound from the chamber when you push the parking brake valve in to release the brakes.
Broken power spring: Age, wear, corrosion and fatigue can cause the heavy coil spring inside the sealed chamber to snap. Once that’s broken, the wheel it’s on will have little to no parking or emergency holding power.
Failed caging bolt or internal seal: O-rings and seals separate the service and emergency sides of the brake chamber. These can wear out over time and allow air to cross over and leak out of the exhaust port or quick-release valve.
In our incident, the chamber diaphragm had failed completely, and the spring was broken. The tech replaced it with a 3030 Long-Stroke Full-Can Clevis. This is a specific configuration of a heavy-duty dual air brake chamber used on semi-truck drive and trailer axles.
Signs the Issue is the Brake Chamber

When a brake chamber fails, the effects on the truck are immediate. First, the truck won’t be able to build or hold air pressure. When the diaphragm rips, air rushes out of the chamber whenever you try to release the parking brakes. This stops the compressor from building enough pressure to move the truck.
In addition, the wheel with the faulty brake chamber may drag or lock up. It needs pressure to hold that spring back, and without it, the spring forces the pushrod out and locks the brakes on that wheel.
Unfortunately, a defective brake chamber is an immediate out-of-service defect for DOT and commercial vehicle regulations. To be approved, you must have it repaired immediately. This is why our on-site fleet service is available 24-7, ensuring your fleet vehicles can be repaired on the spot whenever and wherever they need it.
Emergency Mobile Fleet Repairs in Washington State
Motorplex is part of the FleetEasy Company of Family. With fleet service shops in Auburn and Spokane, we can dispatch our 24-hour emergency mobile fleet repair units throughout Eastern and Western Washington, as well as the surrounding states and provinces.
If you need an immediate repair, as this driver did in Ellensburg, we’ll be there to help.
